Brother HL-5595DNH Manual page 17

Notes on Using the Wireless Network Models
1 For Wireless LAN Function of the Equipment
Operating frequency: 2.4 - 2.4835 GHz

Equivalent isotropic radiated power (EIRP): ≤ 100 mW

Maximum power spectral density: ≤ 20 dBm / MHz (EIRP)

 Carrier frequency tolerance: 20 ppm
 Out-of-band emission power (Outside the 2.4 to 2.4835 GHz frequency band)
≤ -80 dBm / Hz (EIRP)
Spurious emission (radiation) power (Outside the range of the corresponding carrier ± 2.5

times the channel bandwidth):
≤ -36 dBm / 100 kHz (30 - 1000 MHz)
≤ -33 dBm / 100 kHz (2.4 - 2.4835 GHz)
≤ -40 dBm / 1 MHz (3.4 - 3.53 GHz)
≤ -40 dBm / 1 MHz (5.725 - 5.85 GHz)
≤ -30 dBm / 1 MHz (1 - 12.75 GHz for others)
2 For NFC function of the Equipment
 Operating frequency: 13.553 - 13.567 MHz
 The magnetic field strength of emission at the distance of 10 meters away from the
equipment shall not exceed 42 dBμA/m (based on quasi-peak detection mode);
Frequency tolerance: ≤100×10

 Spurious radiation: For the equipment within the 13.553-13.567 MHz frequency band, the
offset threshold from the 140 kHz frequency range at the both ends of the frequency band
is 9 dBμA/m (at 10 meters away, quasi-peak).
3 DO NOT, without appropriate permission, attempt to alter the emission frequency or increase
the emission power (including by installing an additional RF power amplifier), or connect any
external antenna or use any unspecified transmitting antenna.
4 This equipment must not cause harmful interference to other radio services. In case such
interference occurred, the equipment must be stopped immediately and cannot be used until
the appropriate measures are taken to eliminate the harmful interference.
5 This micro-power wireless equipment must accept any interference caused by the legal
operation of other radio services or radiated interference received from the industrial, scientific
and medical appliances.
6 DO NOT use this equipment anywhere near the plane or airport.
-6
A
17