Table of Contents
Advertisement
2.6
RAM and 2.5" Storage Drive installation
Before starting RAM and Storage Drive installation, be sure the system is powered
down (not in sleep mode) and the power has been disconnected. Also, make sure the
components are ready for installation. For specifications and requirement of memory
and storage devices, see Chapter 1: Specifications.
Step 1: Remove the four screws securing the bottom panel, then lift the bottom panel
off the device. If you have previously installed a storage device, be careful to
disconnect the SATA and SATA power cables before completely removing the bottom
panel.
Chapter 2 – Hardware Information
32
Advertisement
Table of Contents
