Table of Contents
Advertisement
RAM installation is complete. If you also need to install the 2.5" SATA Drive, continue to
the next section. If you are done, replace the bottom panel and secure with the eight (8)
screws you removed in Step 1 of this section.
2.7
2.5" SATA Drive Installation
Before installing the SATA Drive, ensure the system is powered down and disconnect
the power cord from the system. Make sure you have the SATA Drive ready to install.
See Chapter 1 for SATA drive specifications for compatibility.
Step 1: If you have not already done so, remove the eight (8) screws from the bottom
of the BOXER-6641 as shown in the figure below. Remove the bottom panel from the
system.
Chapter 2 – Hardware Information
52
Advertisement
Table of Contents
