Table of Contents
Advertisement
Step 2: Attach a thermal pad to the first RAM module, between the board and module.
Then, insert the module at a roughly 30° angle. Gently push down until secured by the
tabs.
Step 3: Install the next RAM module, again first by inserting at a 30° angle, then gently
pressing down until secured.
Step 4: Place a thermal pad on top of this module. If you are not installing a new
storage device, you may proceed to reconnecting and replacing the bottom panel.
Step 5: Attach the 2.5" SATA drive to the drive bracket using four screws supplied.
Step 6: Next, attach the drive bracket to the bottom panel by lining up with the risers
as shown in the diagram.
Chapter 2 – Hardware Information
33
Advertisement
Table of Contents
