Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The speaker does not sound when you close the LCD panel. Use
headphones when using the viewfinder.
SET dial
Speaker
Adjusting the Speaker Volume
CAMERA
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the volume completely by turning the SET dial
down until "OFF
volume again.
Adjusting the Headphones Volume
The headphones terminal also serves as AV terminal. Headphones can only be used
when "
" is displayed on the screen. If not, change the setting following the procedure
below.
CAMERA
MENU
VCR SETUP
(
71)
1. Press the MENU button and select [VCR SETUP].
Select [AV/PHONES
press the MENU button.
2. Turn the SET dial to increase the volume, and down
to lower the volume.
The speaker does not sound when "
Do not connect headphones unless "
You can also adjust the headphones volume during recording.
42
PLAY (VCR)
" appears. Turn the SET dial up to increase the
PLAY (VCR)
], set it to [PHONES
(phones) terminal
CARD CAMERA
CARD CAMERA
AV/PHONES
••AV
] and
" is displayed.
" is displayed as it produces noise.
CARD PLAY
CARD PLAY