Canon Optura 50 Instruction Manual page 139

Problem
The tape stops during
playback pause.
Memory Card Operation
Problem
Memory card cannot be
inserted.
Memory card cannot be
recorded.
Memory card cannot be
played back.
Image cannot be erased.
" " flashes red.
Printing
Problem
The printer is not operating
even though camcorder and
printer are correctly
connected.
Editing
Problem
Dubbing via the camcorder's
DV terminal does not work.
When playback pause continues for more than 4 minutes 30
seconds during playback or audio dubbing, the camcorder
shuts off to protect tape and video heads. Playback the tape
again and press the /
Memory card was not facing the correct direction. Turn the
memory card over and reinsert it.
Insert a memory card.
Memory card is full. Replace the memory card or erase
images.
Memory card is not formatted. Format the memory card.
File number reached maximum value. Set [FILE NOS.] to
[RESET] and insert a new memory card.
SD Memory Card is protected. Change the position of the
protect switch.
Set the camcorder to CARD PLAY mode.
Insert a memory card.
Image is protected. Cancel the protection.
SD memory card is protected. Change the position of the
protect switch.
Card error occurred. Turn off the camcorder. Remove and
reinsert the memory card. Format the memory card if flashing
persists.
1. Set the camcorder to CARD PLAY mode.
2. Disconnect and reconnect the USB cable.
3. Turn off the printer and turn it back on.
Set [AV DV/ ] (OPTURA60) or [AV
[OFF].
Wrong signal format. Dubbing may work via the AV terminal.
Refer also to the instruction manual of the connected device.
Solution
pause button.
Solution
Solution
Solution
DV] (OPTURA50) to
–
E
22
22
104
105
73
22
41
22
103
22
105
–
73
–
139