Table of Contents
Advertisement
Test the System
IMPORTANT: The Base unit and the Keypad can not be within 30 feet of each other when operating . If units are closer than 30
feet the signal will be inconsistent as well as emit speaker feed back . Also, multiple Base units must be no closer than 10 feet
from each other to prevent interference .
Have someone press the CALL button on the keypad at the gate . When the base unit inside the house rings, press the ANSWER
button and talk to the person at the gate to check the connection and range . Then press the GRANT PERMISSION button and
have the person at the gate press any key on the keypad to activate the gate .
Troubleshooting
Make sure all connections are secure and correct .
Other electronic devices in the same area may interfere with the factory ID code . If the system does not communicate at all,
reset the intercom/keypad ID code as follows .
RESET ID: This will require two (2) people .
1 . Open the keypad and locate the "ID SET" button above the batteries .
2 . Locate the "ID SET" button on the bottom of the intercom base unit .
3 . Make sure the "antenna-to-antenna" distance between the keypad and the base unit is at least 30 feet .
4 . Reset the MASTER Intercom base unit's ID Code .
Batteries must be installed and the units turned ON .
A . Press the "ID SET" button on the Keypad until you hear a beep, then release . This erases all stored ID Codes .
B . Press the "ID SET" button on the MASTER Intercom for approximately 2 seconds then release . You will hear ONE beep from
the Intercom and TWO from the Keypad, which means the ID Codes are reset .
C . Test the system by pressing the CALL button on the Keypad to see if the Intercom receives the signal .
NOTE: If the system is now working you will need to reset any additional Intercom you have installed . See "Adding Additional Intercoms" .
IMPORTANT: Base units must be no closer than 10 feet from each other to prevent interference .
If all connections are correct and the ID SET change didn't solve the communication problem, please call our Technical
Service Department at 1-800-543-1236 Monday - Friday 8:00 am to 7:00 p .m . (ET) .
ID SET buttons
Intercom - Bottom
15
+
0
–
1 2 3 4 5 6 7 8 9
JUMPER
RELAY
AC/DC
OUTPUT
POWER IN
ID SET
RESET
+
– +
–
–
–
+
+
Keypad - Inside
Advertisement
Table of Contents
