Table of Contents
Advertisement
Delete ALL Entry Codes:
• Press and release PROGRAM button .
• Enter the Master Code then press and release PROGRAM button .
• Enter 0, 7 then press and release PROGRAM button .
• Beeper beeps 3 times to confirm that the All Entry Codes are deleted .
Example:
Key press sequence to delete all entry codes from memory .
(1234 is the Master Code)
1 2 3 4
0 7
The round black dot is the 'PROGRAM' button .
Intercom Description
Intercom - Face
Intercom - Bottom
POWER Light:
LED is GREEN when charging on AC power source and RED during battery power
mode . Blinking RED indicates low battery on Base unit .
KEYPAD BATTERY INDICATOR Light:
LED turns ON when keypad battery is low .
GRANT ACCESS Button:
The GRANT PERMISSION button must be pressed then the
person at the keypad can press any key to open the gate .
END CALL Button:
Allows user to terminate the call .
9 Vdc Transformer Plug:
Transformer plugs here to charge the base unit battery .
VOLUME Control:
Controls volume level of speaker .
BATTERY ACCESS Cover:
Rechargeable 3 .6 Volt Ni-MH battery included .
ON/OFF Switch:
Turn OFF to conserver power when battery operated .
ID SET button:
This button is used only when there is another pair of wireless
intercom units nearby causing interference .
Normal Keypad operation:
• If the user enters a 4-digit code that is matched to one of the 25
stored codes, the STATUS light should blink twice and the beeper
should beep twice to confirm that a matched code is entered .
• No more than 20 key presses are allowed to obtain the 4-digit
entry code .
Example:
1234 is one of the codes stored in one of the memory
location .
The user can enter 'x1234' or 'xxxxxxxxxxxxxxxx1234' and the gate
should be activated (x is any key) . If more than 20 key presses is
entered without matching one of the codes, then the STATUS light
should be flashing rapidly and no entry will be accepted for the
next 40 seconds . The user must not enter any code for at least 40
seconds before the unit returns to normal operation . Otherwise it
remains in this 'lock-down' mode . Once the user enters a matched
code, any subsequent key press within the next 40 seconds will re-
activate the keypad .
PUSH TO ANSWER/TALK Button:
Used to answer CALL from keypad .
HOLD to talk - RELEASE to listen .
12
Advertisement
Table of Contents
