Advertisement
Step 5
You will need
5 x Small Cam
1 x Dowel
(H1)
Nuts (H4)
Flat head
screwdriver
Insert 1 x Dowel (H1) into Drawer Front (P5) as shown.
Insert 5 x Small Cam Nuts (H4) into the holes of Drawer Sides (P6, P7) and Drawer Support (P10).
Rotate the cam nuts so the arrows point towards the incoming cam bolts.
Align the holes together, secure Drawer Sides (P6, P7) and Drawer Support (P10) into place,
tighten the cam nuts using a Flat head screwdriver.
Step 6
Slide Drawer Base (P8) in through the grooves
on Drawer Sides (P6, P7).
Step 7
You will need
6 x Long
Phillips head
Screws (H2)
screwdriver
Attach Drawer Back (P9) to Drawer Sides (P6, P7)
and Drawer Support (P10) with 6 x Long Screws (H2),
make sure that the groove lines up the whole way around the drawer.
Tighten the screws using a Phillips head screwdriver.
www.fantasticfurniture.com.au
(P6)
H4
H4
(P5)
(P6)
H2
H2
(P6)
This is how a cam nut works ........
(P10)
H4
(P7)
H1
H4
(P8)
(P7)
H2
H2
(P9)
H2
(P7)
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
H4
H2
PAGE 7
Advertisement
