June 13, 2008 Final Draft
Installing the logic card
Follow these steps to install the logic card:
Figure 9. Opening the paper door and ribbon door
1. Turn off the power to the 4610.
2. Open the paper door by pressing the blue release button ( A in Figure 9).
3. As shown in Figure 9, open the ribbon door ( B ) by pulling downward.
Attention
Printer should be powered off. The following ESD handling procedure is
recommended: You should touch the metal on the printer frame with the back
of your hand before making contact with the printer. Also, see "Electrostatic
Discharge (ESD)" on page 46.
DRAFT
Installing 4610 Models 2CR and 2NR
A
Chapter 2. Installing the 4610 Models 2CR and 2NR
B
13