Lubrication And Maintenance Chart - Scag Power Equipment SWZ Series Operator's Manual

BREAK-IN
8 HOURS (DAILY)
40 HOURS (WEEKLY)
100 HOURS (BIWEEKLY)
500 HRS OR ANNUALLY
X
Check all hardware for proper tightness
X
Change engine oil and filter at 5 hours
X Check engine oil
X Remove debris from under belt cover
X Sharpen cutter blades
X Grease spindle bearings
X Clean air filter
X Check belt tension
X Check tire pressure
X Check battery level
X Replace air filter
X Grease caster wheel bearings
X Grease caster wheel pivot shafts
X Grease idler pulley bracket on cutter deck
X Change hydrostatic oil filter
X Change engine oil and filter
X Grease idler arm pivots
X Grease brake hand lever
X Grease brake actuator levers
X Check all hardware for proper tightness
X Adjust air gap on electric clutch
X Drain hydraulic system and replace oil
LUBRICATION & MAINTENANCE
+ Grease spindle until grease comes out the relief valve
Compatible Greases:
PROCEDURE
14
Lidok EP #2 (found at industrial shops)
Ronex MP (Exxon service stations)
Shell Alvania (Shell service stations)
Mobilux #2 (Mobil service stations)
Super Lub M EP #2 (Conoco service stations)
COMMENTS
Do not over fill
More often if needed
More often if needed
+ US Lithium MP White Grease 2125
More often if needed
Adjust as needed
Add or adjust as required
Adjust as needed
More often if needed
Chassis grease
Chassis grease
Chassis grease
Clean area before removing the filter
See engine manufacturer information
Chassis grease
Chassis grease
Chassis grease
Contact your Scag dealer for information about
making this adjustment.