Please Fasten The Screws Through; Step 4; These Holes For This Step; You Will Need - fantastic furniture Java Lamp Table 1 Drawer Manual

Step 4

You will need

6 x Screws
2 x Slides
12mm (H18)
(H19)
Phillips Head 8 x Dowels
Screwdriver
ø8
mm (H3)
Mallet
Note the position
of the rubber stopper
H19-1
Attach 2 x separated slide tracks (H19-1) onto 2 x side panels (P3) with 6 x screws (H18),
using a phillips head screwdriver as shown.
Ensure the slide tracks (H19-1) are attached so the rubber stopper is near the gooves
on the panels.
Insert 4 x dowels (H3) into each panel (P3) as shown.
Use a mallet to gently tap the dowels into place if needed.
fantasticfurniture.com.au
Separate the 2 x slide runners (H19-2) and slide tracks (H19-1)
from the slides (H19) by following the steps below:
Extend the slide runner (H19-2) all the way out.
Press down the plastic release lever on the slide and pull out
the slide runner (H19-2) completely.
H19
Slide runner H19-2
Adjust runner to access the screw holes.
H19-1

Please fasten the screws through

these holes for this step.

H19-1
H18
H3
H3
H18
H18
(P3)
H3
H19
Slide track H19-1
H19-1
H3
X
2
Page 7