Lexus GS450h Owner's Manual page 302

Hide thumbs Also See for GS450h:

Table of Contents

4-5. Using the driving support systems

Changing the vehicle-to-vehicle distance (vehicle-to-vehicle distance

control mode)

Pressing the button changes the vehi-

cle-to-vehicle distance as follows:

The vehicle-to-vehicle distance is set

automatically to long mode when the

power switch is turned ON mode.

If a vehicle is running ahead of you, the preceding vehicle mark will also be displayed.

Vehicle-to-vehicle distance settings (vehicle-to-vehicle distance con-

Select a distance from the table below. Note that the distances shown corre-

spond to a vehicle speed of 80 km/h (50 mph). Vehicle-to-vehicle distance

increases/decreases in accordance with vehicle speed. When the vehicle is

stopped by system control, the vehicle-to-vehicle distance will be about 3 m

(10 ft.) to 5 m (16 ft.) regardless of the vehicle-to-vehicle distance setting.

Resuming follow-up cruising when the vehicle has been stopped by sys-

tem control (vehicle-to-vehicle distance control mode)

After the vehicle ahead of you starts off,

push the lever up.

Your vehicle will also resume follow-up

cruising if the accelerator pedal is

depressed after the vehicle ahead of

you starts off.

GS450h_300h_OM_OM30F92E_(EE)

Distance options

vehicle mark

Vehicle-to-vehicle distance

Approximately 50 m (160 ft.)

Approximately 40 m (130 ft.)

Approximately 30 m (100 ft.)