C.cable Tracing Test - NOYAFA NF-868A Instruction Manual

Test result 4: RJ11(TEL) cable length test
I nsert one end of the RJ11 cable to be tested into "RJ11" port of the main
tester, the other end needs no connection. select "Tel(6)" mode, return to the
main menu, and select length test, and then press "ENTER" key to perform
length test with the equipment, the following interface will be shown:
1
2
3
4
And then press "UP" or "DOWN" key, the following interface will further be shown:
5
6
It indicates that length of telephone cable is 10.1m
with main tester, the other end needs no connection, so it show "Open" in the
pictureAt this time,press "ENTER" to return to the main menu,and then press
"ENTER" key for re-test.. .
Test result 5: BNC cable length test
If to insert one end of the BNC cable to be tested into "BNC" port of the main
tester, the other end is an open circuit, select "BNC(2)" mode, return to the
main menu, and select length test, and then press "ENTER" key to perform
length test with the equipment, the following interface will be shown:
1
2
It indicates that length of BNC cable is 10.1m. At this time, press any key to
return to the main menu, and then press "ENTER" key for re-test.
Your excellent helper in cable test!
11
Open 1 0.1m
Open 1 0 0. m
Open 10. m 1
10. m 1
Open
Open 1 0.1m
Open 1 0.1m
Only one end of cable connect
Open 1 0.1m
1 0.1m
Open
c. Cable tracing test:
After powering on the main tester and entering main test menu, press "UP",
"DOWN" key to move " " cursor to cable scan, and then press"ENTER"
key to find the line. The following interface will be shown:
Scanning
Connect the cable to be found with the corresponding RJ45(Scan) port
emitter , (RJ11,USB or BNC). Take network line finding as an example:
connect the network cable to be found with Rj45 port, move "
cable scan, and press "ENTER" key to perform line finding test as shown in
the figure below:
. . .
of the
" cursor to
Your excellent helper in cable test!
12