Section 3 | Control Panel Operation - USA Lab UHC Series User Manual

Section 3 | Control Panel Operation

3.1 LCD Display Operation
[ Prior to running the chiller, your fluid loop should be setup and the tank filled ]
Press Set (14) to enter the temperature set menu. Adjust the value using the Up (15) or Down (16). Then
Press Set (14) again to save the desired value (5). Next press Loop (10), then Cooling (11) and Heating
(12). This turns on the fluid pump, heating, and cooling.
Disclaimer – Parameters are not allowed to be modified by end users. This is to protect the equipment
from accidental damage. Modifying parameters for any reason, without our knowledge and
permission will constitute a void of the warranty.
11