Advertisement
Quick Links
NECESSARY MATERIAL:
GPRS modem board with 2 washers and 1 M3 nut.
Antenna connector hose with 1 nut and 1 glower. In the built-in model, an M6 insulator and an M8
washer will also be supplied, to isolate the antenna connector from the metal box.
Adhesive Brackets for flanges, 4 for embedding or 1 for box.
Flanges, 4 for embedding or 1 for box.
Antenna.
IMPORTANT: Before installing the modem, the controller must be updated to the current version, and activate the
option, if applicable.
MOUNTING BUILT-IN MODEL:
1. Disconnect power to the controller.
2. Remove the 6 screws that hold the keyboard.
3. Lift the keyboard.
4. Place the modem behind the keyboard. First, place one of the supplied washers between the keyboard
spacer and the modem circuit. Then place another washer between the modem and the nut.
The GPRS modem will only be properly installed if its connector is fully mated to the keyboard board
connector, without any space between them.
GPRS/SMS OPTION INSTALLATION
IN AGRÓNIC 5500
Advertisement
Related Manuals for Progres AGRONIC 5500
Summary of Contents for Progres AGRONIC 5500
- Page 1 GPRS/SMS OPTION INSTALLATION IN AGRÓNIC 5500 NECESSARY MATERIAL: GPRS modem board with 2 washers and 1 M3 nut. Antenna connector hose with 1 nut and 1 glower. In the built-in model, an M6 insulator and an M8 washer will also be supplied, to isolate the antenna connector from the metal box. ...
- Page 2 Be careful not to tighten the nut too much, it can reverse effect and lift the modem from the other side. 5. Antenna connector attachment: the connector will be located in the hole designated for this purpose located at the back of the metal drawer indi- cated as “gsm /gprs”.
- Page 3 MOUNTING BOX MODEM: 1. Disconnect power to the controller. 2. Remove the 4 screws that hold the keyboard. 3. Lift the keyboard and disconnect the 2 wires that connect the keyboard board with the outputs board. 4. Place the modem behind the keyboard. First, place one of the supplied washers between the key- board spacer and the modem board.
- Page 4 6. Place the connector and fasten it by means of the nut on the outside, and the glower on the inside. 7. Reconnect the two cables disconnected at point 3. 8. Place the SIM card as shown in the photo. 9.