Intex CS15220 Owner's Manual page 32

(241IO) SALTWATER SYSTEM & SAND FILTER PUMP (14" & 16") ENGLISH 7.5" X 10.3" PANTONE 295U 08/09/2013
TROUBLESHOOTING GUIDE (continued)
LED PANEL
CODE
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
1. Circulation line is blocked.
2. Incorrect inlet and outlet hose
direction.
3. Scale on the flow sensor.
4. Flow sensor cord is loose.
5. Device is set and operating in
backwash, rinse or waste mode.
6. Flow sensor failure.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
1. High salt level.
2. Possible electrolytic cell failure.
1. Display and all lights are off - the
system does not power up.
SAVE THESE INSTRUCTIONS
PROBLEM SOLUTION
• If your unit has plunger valves, ensure that they
are open.
• Clear your basket and cell from debris and dirt.
See "Maintenance".
• Depress the 6-way valve, release all trapped air
in the circulation line.
• Check the direction of the inlet and the outlet
hose. Reverse the hoses if necessary. See "Set
Up Instructions".
• Clean the flow sensor, paying special attention
to the hinge. See "Maintenance".
• Plug the flow sensor firmly into the flow sensor
receptacle.
• Ignore the alarm, finish the backwash, rinse or
waste operation then turn the power switch OFF
and ON again to reset the alarm.
• Contact Intex Service Center.
• Remove the electrolytic cell for inspection. Clean
it if necessary. See "Maintenance".
• Add salt. See "Salt & Pool Water Volumes".
• Ensure that the cell cord is plugged firmly into
the cell housing receptacle.
• Contact Intex Service Center. Replace the cell if
needed.
• Partially drain the pool and refill it with fresh
water. See "Salt & Pool Water Volumes".
• Contact Intex Service Center. Replace the cell if
needed.
• Household voltage is too high or too low
(+ 20%). Check the voltage is within the Range
stated on the device housing.
• Contact Intex Service Center.
English
241A
Page 32