Table of Contents
Advertisement
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS (continued)
Installation and Cabling
Connecting to the PC
Read Usage Notes (
to
3
Make sure that the display signals produced by your PC meet the specifications of this product.
For the specifications of this product, see Product Specifications (
Choose an appropriate site and install the product on a level table where the stand is secure.
Install the monitor to have ready access to a power socket.
Make sure that the monitor's power switch is off.
The monitor is shipped with the power switch off.
Make sure that your PC's power switch is off.
Interconnect the signal input terminal (RGB1) on the monitor rear panel and the display signal
output terminal of the PC to each other using the signal cable included.
Optional cables are needed to connect to the RGB2 input and audio input terminals.
If the signal cable included does not match your PC, consult your dealer after reading the section "Signal
Input".
26
Insert one end of the power cable included into the rear-panel power cable connector and the other
end into a mains.
Turn on the monitor, then the PC to make sure that a display image appears on the monitor screen.
For instructions on turning on the monitor and adjusting its display images, see "Operating Instructions"
(
14
to
19
).
Power cable
Power cable
connector
AUDIO
RGB2
(MONO)
R
L
V
H
12
) carefully to ensure maximum safety before proceeding to these steps:
8
Monitor rear panel
RGB INPUT
[ BNC ]
RGB1
B
G
R
[ D-SUB ]
25
to
27
).
PC
Advertisement
Table of Contents
