Hitachi CMP307XE User Manual page 6

All manuals and user guides at all-guides.com
SAFETY GUIDELINES (continued)
Fire or electric shock may cause death or serious injury
Warning
unless you follow the instruction below.
If something smells strange or smoke comes from the monitor:
Turn off the monitor and disconnect the power plug from the mains immediately.
Contact service center after confirming that the smoking has stopped.
If you continue to operate the monitor with such abnormal condition, it may cause fire or you may
receive an electric shock.
Do not drop water or a foreign substance on to the monitor.
If you drop water or a foreign substance on to the monitor, it may cause fire or an electric shock.
If it happens turn off the monitor and disconnect the power plug from the mains and ask service center
for instruction.
Do not put the monitor on an unstable place.
If you put the monitor on an uneven or unstable place, it may fall down and you may be injured.
Put the monitor on a flat surface strong enough to take the weight.
Do not apply shock to the monitor.
If no picture, glass broken, smoke or something is smelling after applying shock to the monitor, turn
off the monitor and disconnect the power plug from the mains immediately. Then, call the service
center.
If you continue to operate the monitor with such abnormal conditions, it may cause fire or you may
receive an electric shock.
Do not disassemble or modify the monitor.
There is high voltage portion inside of the monitor. Disassembling or modification of the monitor may
cause fire or electric shock.
Do not use the monitor in wet environment.
If you use the monitor in a wet place such as bath or shower room, it may cause fire or electric shock.
Using the monitor beside a window when snowing or raining or by a seaside are not recommended.
Do not damage or modify the power cord.
If you put something heavy on the power cord or pull, squeeze, heat the cord, it may be damaged and
it may cause fire or electric shock.
If the power cord is damaged, call service center.
Fire or electric shock may cause death or serious injury unless you follow the
Warning
instruction.
The enclosed power cord must be used!
Failure to do so may cause electric shock hazard or fire hazard.
In USA/Canada, use a UL LISTED/CSA LABELLED or CERTIFIED power cord set meeting the
following specifications :
Rating: min. 125V, 10A , Length: max. 3.0m , Type: SVT or SJT
Plug type: NEMA 5-15P figure, Parallel blade, Grounding type
In Europe, a proper European standard approved power cord is to be used with this monitor.
For a rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm
mm must be used.
2
Use only the correct voltage power outlet with safety ground connection!
100 - 120 V for USA, Canada, etc.
200 - 240 V for Europe, etc.
(This monitor will automatically adjust to the input voltage 100 - 120 / 200 - 240V.)
Be careful of power cord connection!
Before inserting the plug of the power cord into a socket of the correct voltage, check that the
connection portion of the power cord is clean (with no dust). Then, insert the plug of power cord into
the socket firmly, otherwise it may cause electric shock or fire hazard.
Do not touch the power plug when lightning is close to you.
You may receive an electric shock.
4
or H05VVH2-F 3G 0.75
2