Table of Contents
Advertisement
NL Troubleshooting
Malfunction
Drying time is too long.
Water is leaking.
Laundry is too damp.
42
Cause and Troubleshooting
Heat exchanger is contaminated.
→ "Open base unit", page 36 .
1.
Clean heat exchanger.
2.
→ "Cleaning the bottom unit", page 36
→ "Close base unit", page 37 .
3.
The appliance is not leveled properly.
Adjusting the device
▶
The seal of the heat exchanger cover is dirty.
Clean the seal of the heat exchanger cover.
▶
→ "Clean the filter system of the bottom unit",
Page 33
Water drain hose is not connected correctly.
Make sure that the water drain hose is connected
▶
correctly.
→
"Connecting the water drain hose", Page 14
Handle of the heat exchanger cover not closed
correctly.
Make sure that the heat exchanger cover handle is
▶
properly closed.
→ "Close base unit", page 37
Inappropriate program set for the type of fabric.
Set a time program for post-drying.
▶
→ "Programs", Page 26
Power supply has failed.
Check whether the interior lighting or other
▶
appliances are working.
The load quantity is too high.
Pay attention to the maximum load of the
▶
→ "Programs", Page 26 .
Warm laundry feels damper than it actually is after
the end of the program.
Remove the laundry from the drum immediately after
1.
drying.
Spread the items out to let them cool.
2.
Inappropriate drying target set.
→
"Change drying target", page 25 .
▶
Drying target not adjusted.
→ "Adjust drying target", Page 25 .
▶
Advertisement
Table of Contents
