Table of Contents
Advertisement
Malfunction
Condensation water in the
condensed water reservoir
voir, although the water
drain hose is attached
locks.
Program does not start.
The program duration
changes during
drying.
Pump sound.
Buzzing sound.
Drying time is too long.
Cause and Troubleshooting
The device uses condensed water for automatic self-
cleaning.
No error - no action required.
▶
Water drain hose is not connected correctly.
Make sure that the water drain hose is connected
▶
correctly.
→
"Connecting the water drain hose", Page 14
Child lock is activated.
→ "Deactivate child lock", page 35
▶
Start/Pause was not pressed.
Press Start/Pause.
▶
No program set.
→ "Set program", page 30 .
1.
→ "Starting the program", Page 31 .
2.
The program sequence is electronically optimized. This
may lead to changes in the program duration.
No error - no action required.
▶
Condensate pump active.
No error - normal operating noise.
▶
Compressor venting active.
No error - normal operating noise.
▶
The filter in the bottom unit is dirty.
→ "Clean the filter system of the bottom unit",
▶
Page 33
Fluff filter is dirty.
→
"Cleaning the fluff filter", Page 31
▶
Ambient temperature is higher than 30°C.
Make sure the ambient temperature is below 30°C.
▶
Ambient temperature is below 15°C.
Make sure that the ambient temperature is above
▶
15°C.
Insufficient air circulation at the location of the
device.
Ventilate the installation site of the device.
▶
Air inlet of the device is blocked.
Make sure that the air inlet of the device is kept
▶
clear.
Troubleshooting NL
41
Advertisement
Table of Contents
