Tripp Lite NPOE-EXT-2X1G30 Quick Start Manual page 6

Installation
Multiple Extender Installation
Notes:
• You may only cascade three PoE extender units up to 1312 ft. (400 m)
in a single installation.
• Prior to connecting the RJ45 cable to input/output ports, install the
included cable glands onto the cable. Refer to Cable Wire and Crimp
Steps below.
1. Using a Cat5e/6 cable (up to 328 ft. / 100 m long), connect your
powered source device (such as a PoE switch) into the "IN" port on
the unit.
2. Using another Cat5e/6 cable (up to 328 ft. / 100 m long), connect the
"OUT" port of the first extender to the "IN" port of the second extender.
3. Repeat Step 2 up to two more times for each additional PoE extender
you add, or connect your remote PoE powered device (PD) to the "OUT"
port of the second PoE extender.
Notes:
• The third PoE extender will only supply IEEE 802.3af up to 7W.
• Your PoE source must meet or exceed IEEE 802.3at standards.
Multi-Extender Installation Diagram
PoE
Switch
Max 328 ft. (100 m)
21-06-161-933F47-EN.indd 6 21-06-161-933F47-EN.indd 6
PoE Extender
PoE Extender
Max 328 ft. (100 m)
PoE Extender
Max 328 ft. (100 m) Max 328 ft. (100 m)
6
Camera
8/19/2021 11:12:07 AM 8/19/2021 11:12:07 AM