Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Lippert Components Power Stance
Summary of Contents for Lippert Components Power Stance
- Page 1 Power Stance Tongue Jack ™ OWNER'S MANUAL...
- Page 2 Helical cut gears reduce noise and improve operating efficiency. Enhanced rocker switch improves its durability. The Power Stance tongue jack is protected by an in-line fuse and has an18” stroke with a 3,500-lb capacity. A chain holder under the jack head provides a place to store chains when they are not attached to the tow vehicle.
- Page 3 Safety Read and understand all instructions before installing or operating this product. Adhere to all safety labels. This manual provides general instructions. Many variables can change the circumstances of the instructions, i.e., the degree of difficulty, operation and ability of the individual performing the instructions. This manual cannot begin to plot out instructions for every possibility, but provides the general instructions, as necessary, for effectively interfacing with the device, product or system.
- Page 4 Operation NOTE: The Power Stance power tongue jack can be operated by utilizing either a battery stored in the trailer, or by drawing power from the tow vehicle using the optional Power Swap Auxiliary Cord™. NOTE: When RET (Fig. 2A) or EXT (Fig. 2B) on the switch is pushed, the light above the switch (Fig. 3A) will turn on automatically, and remain on for five minutes.
- Page 5 Power Stance tongue jack is fully retracted. Reconnect all electrical and mechanical connections between the trailer and tow vehicle. Make sure the leg of the Power Stance tongue jack is fully retracted and tire chocks are removed prior to moving the tow vehicle.
- Page 6 Manually unhitching from tow vehicle: A. Chock the tires of the trailer. B. Be sure the footpad of the Power Stance tongue jack is pinned securely in place with the clevis pin and hairpin cotter pin (Fig. 5B). C. Make sure the ground surface under the power tongue jack is firm and level.
- Page 7 Troubleshooting Fuse The Power Stance tongue jack is provided with a 30A ATO-type in-line fuse which will need to be replaced if it blows. The battery must be fully charged prior to operating the Power Stance tongue jack. Low voltage from the battery will cause the fuse to blow prematurely.
- Page 8 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (LCI). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the Power Stance and is the answer not in the manual?
Questions and answers
On a Lippert power tongue Jack, is it possible to rotate the switch box so it does not hit the tailgate of the truck when opening?
Yes, the switch box on a Lippert Components Power Stance tongue jack can be rotated. The model now includes pre-drilled and tapped holes that allow the head to be rotated 90 degrees, helping to avoid interference with larger truck tailgates.
This answer is automatically generated