Maintenance; Removing And Replacing The Warming Drawer; Oven Vent - LG LSRE307ST Owner's Manual

1. CAUTION - Always turn off all power to the warming
drawer before attempting to remove it.
2. Open the drawer to the fully opened position.
3. Remove the 2 screws (right and left sides). (refer to the
drowing below)
4. Locate glide lever on each side of drawer, push down on
the left glide lever and pull up on the right glide lever.
5. Pull the Warming Drawer away from the range.
WARNING
• Always turn off all power to the warming
drawer before attempting to remove it.
- Failure to do so can result in severe personal
injury,death or electrical shock.
Remove screw
Lever
Push down with finger

MAINTENANCE

Lever
Pull up with finger
- 31 -
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide.
3. Align the glide on each side of the drawer with the glide
slots on the range.
4. Push the drawer into the range until levers click
(approximately 2 inches). Pull the drawer open again to
seat bearing glides into position. If you do not hear the
levers click or the bearing glides do not feel seated,
remove the drawer and repeat steps 2-4.
This will minimize possible damage to the bearing glides.