Operation; Setting The Clock; Minimum & Maximum Control Pad Settings; Setting The Timer On/Off - LG LRE3012SB Owner's Manual & Cooking Manual

SETTING THE CLOCK

The CLOCK pad is used to set the clock. The clock has been
preset at the factory for 12 hours operation. When the range
is first plugged in, or when the power supply to the range has
been interrupted, the timer in the display will show with
power failure "PF". You can make a choice between 12-hour
clock and 24-hour clock (refer to the page 17):
To set the clock (example below for 1:30):
1. Press CLEAR OFF pad.
2. Press CLOCK pad.
3. Press 1, 3, 0 pads to set the time
of day to 1:30.
4. Press START pad.
The clock will start.
MINIMUM & MAXIMUM
CONTROL PAD SETTINGS
All of the features listed have minimum and maximum time
or temperature settings that may be entered into the control.
An entry acceptance beep will sound each time a control pad
is pressed.
An entry error tone (3 short beeps) will sound if the entry of
the temperature or time is below the minimum or above the
maximum settings for the feature.
MIN. TEMP.
FEATURE
/TIME
BAKE TEMP. 170°F / 75°C
BROIL TEMP. LO(400°F)
SELF CLEAN TIME 2 hours
WARM
RADIANT ELEMENT
PROOF

OPERATION

MAX. TEMP.
/TIME
550°F / 285°C
HI(550°F)
4 hours
170°F(75°C) / 3 hours
Default: 12 Hr.
Default: 12 Hr.
- 15 -

SETTING THE TIMER ON/OFF

The TIMER ON/OFF serves as an extra timer in the
kitchen that will beep when the set time has run out. It does
not start or stop cooking. The TIMER ON/OFF feature can
be used during any of the other oven control functions.
To set the Timer (example for 5 minutes):
1. Press TIMER ON/OFF pad twice.
"0:00" and "HR" inside "O" will
appear and "TIMER" will flash in
the display.
2. Press the number pads to set the
desired time in the display (press
"5" pad).
If you make a mistake press the
TIMER ON/OFF pad and begin
again.
3. Press TIMER ON/OFF pad. The
time will count down with "5:00"
and "TIMER" will show in the
display.
Note:
4. When the set time has run out,
"End" will show in the display. The
clock will sound with 3 beeps
every 15 seconds until TIMER
ON/OFF pad is pressed.
Note:
If the remaining time is not in the display, recall the
remaining time by pressing the TIMER ON/OFF.
Note:
1. If you press TIMER ON/OFF pad once, it allows you to make
a "second" unit of timer setting.
(for example: if you press "5" and "6", it means 56 seconds)
2. If you press TIMER ON/OFF pad twice, it allows you to make
a "minute" unit of timer setting.
(for example: if you press "5" and "6", it means 56 minutes)
To cancel the Timer before the set time has run out:
1. Press TIMER ON/OFF pad once.
The display will return to the time
of day.
If TIMER ON/OFF is not
pressed the timer will return
to the time of day.