Howard Miller 611319 Set Up And Operating Instructions

CLOCK SETUP INSTRUCTIONS
1. Move the clock close to its final location for assembly and setup. Make sure the clock is positioned firmly on the floor.
Levelers are provided on the bottom of the clock (Figure 1). Adjust levelers for maximum stability and proper alignment.
WARNING: ENSURE CLOCK IS POSITIONED SQUARE AND FIRM ON THE FLOOR SO THAT IT WILL NOT FALL OVER. KEEP
CHILDREN AWAY FROM THE CLOCK.
WARNING: KEEP PLASTIC BAGS AND SMALL PARTS AWAY FROM CHILDREN
Supply
2. Locate the Power Supply (Figure 2) and connect it to the Lamp Cord located at the back of the clock base (Figure 3).
3. Move the clock to the final location and plug. See page 4 for Safety Strap installation instructions.
4. Plug the Power Supply into an electrical outlet. Turn the Lamp on by touching the Round Metal Touch Plate on the back of the clock base (figure 4).
There are four levels of lighting: low, medium, high, and off.
5. The direction of the light may be adjusted by pushing gently with your finger on the Lamp (figure 5).
Round Metal
Touch Plate
and OPERATING INSTRUCTIONS
Floor Leveler
Figure 1
Power
Appearance may vary.
Figure 2
Figure 4
FLOOR CLOCK SETUP
Figure 3
1
Power
Supply
Cord
Lamp
Cord
Lamp
Figure 5