Led Cannot Be Seen At All; Cannot Install The Mp Drivers - Canon PIXMA MP210 Series Quick Start Manual

Error Code
E, 2, x An error requiring
servicing might have
E, 3, x
occurred.
E, 4, x

LED Cannot Be Seen At All

Cause
The machine is not powered on or the
LED is in the screen-saver mode.

Cannot Install the MP Drivers

Cause
Unable to proceed beyond the Printer
Connection screen.
46 Troubleshooting
Cause
Make sure that the protective material is removed from the FINE Cartridge
Holder, then turn the machine off and unplug the power cord of the
machine from the power supply. After a while, plug the power cord of the
machine back in, and then turn on the machine. If the same error occurs,
contact your Canon service representative.
If the Power lamp is off
The machine is not powered on. Connect the power cord and press the ON/
OFF button. The machine will power on and the LED will light.
If the Power lamp is lit
The LED may be in the screen-saver mode. On the Operation Panel, press a
button other than the ON/OFF button.
If you were unable to proceed beyond the Printer Connection screen, follow
the procedure below to reinstall the MP Drivers.
(1)Click Cancel on the Printer Connection screen.
(2)Click Start Over on the Installation Failure screen.
(3)Click Back on the screen that appears next.
(4)Click Exit on the PIXMA XXX screen (where "XXX" is your machine's name),
then remove the CD-ROM.
(5)Turn the machine off.
(6)Restart your computer.
(7)Make sure you have no application software running, including anti-virus
software.
(8)Follow the procedure described in your setup sheet to reinstall the MP
Drivers.
Action
Action
Action