Ethernet Settings - ZyXEL Communications PLA6457 User Manual

Table 7 Configuration Screen (continued)
LABEL
IPv6 address /
prefix
Default
Gateway
DNS
IPv6 link-local
address
IPv6 SLAAC
address
Click Ok for the changes to take effect.
Note: All changes except the DNS server will only take effect after a system reboot.

3.5 Ethernet Settings

Use the Ethernet screen to view information on the PLA's Ethernet port. as well as set the PLA's power
saving mode.
Figure 11 Ethernet Screen
The following table describes the labels in this screen.
Table 8 Ethernet Screen
LABEL
Ethernet
External Interfaces
Interface
Speed
Chapter 3 Web Configurator
DESCRIPTION
Enter the IPv6 address you wish to assign to your PLA and the address prefix length to specify
how many most significant bits in an IPv6 address compose the network address.
This field is only available when you select No in the DHCP enabled field.
Enter the IP address of the next-hop gateway. The gateway is a router connected to your PLA.
The gateway helps forward packets to their destinations.
This field is only available when you select No in the DHCP enabled field.
Enter the IPv6 DNS server address you configure manually.
This field is only available when you select No in the DHCP enabled field.
This field displays the IPv6 link-local address and the network prefix that the PLA generates itself
for the interface.
This field displays the IPv6 SLAAC (Stateless Address Auto-configuration) IP address and prefix
obtained from an IPv6 router in the network.
DESCRIPTION
This shows ETHA and ETHB (PLA's Ethernet port).
This shows a link rate of 100 Mbps for ETHA, and a link rate of 1000 Mbps for ETHB.
PLA6457 User's Guide
22