Reset Button - ZyXEL Communications PLA6457 User Manual

Figure 6 Two Separate G.hn Networks
G
If the Powerline (
connection process, making certain you press the ENCRYPT buttons for the correct time and
within 2 minutes of each other. If that does not work see Section 5.4 on page 36 for suggestions.
See Troubleshooting in
the lights.

2.4 RESET Button

The RESET button allows you to reset the PLA to the factory defaults. It also unpairs the PLA from a
network.
The following table summarizes the actions that occur when the RESET button is pressed for specific
lengths of time.
Table 5 RESET
TIME
10 to 15
seconds
Note: The domain name is unknown when you use the RESET button. You can then pair the
PLA to a different network.
See Troubleshooting in
the lights.
Chapter 2 RESET and ENCRYPT Buttons
E
H
) lights on both s do not light up, the
PLA
Chapter 5 on page 36
ACTION
Clear all user-entered
configuration information and
return the device to its factory
defaults.
Chapter 5 on page 36
PLA6457 User's Guide
F
s are not connected. Repeat the
PLA
for suggestions on problems with the ENCRYPT button and
POWER LIGHT BEHAVIOR
The power ( ) light blinks and
then shines steadily.
for suggestions on problems with the ENCRYPT button and
15
POWERLINE LIGHT BEHAVIOR
The Powerline ( ) light turns
off when it disconnects from the
G.hn Network.