Bose AmPlus 50 Supplement Manual page 15

OPTI-VOICE
2. To adjust the levels for the paging system, follow these steps:
1. While another person is speaking into the microphone, adjust the page trim on the
Opti-Voice card until the compressor LED on the Opti-Voice card flashes red during the
loudest speech passages. Then, turn the trim down slightly until the LED glows green at
all times. If the Opti-Voice compressors are disabled, turn the trim down slightly until the
LED no longer flashes red.
2. While continuing to speak into the microphone, slowly turn the page trigger level control
down (to the left) until paging is disabled and the page trigger LED no longer glows
green. Turn the page trigger level control back to the right until the paging comes ON
again.
3. Now have the speaker stop speaking. The page trigger LED should go out and the
music should fade back in.
4. Have the person resume speaking. The page returns and the music source has
disabled.
5. Adjust the page level until the person speaking is just loud enough to be heard clearly.
Note: Be sure to set the paging level loud enough to be heard in noisy environments,
such as when a room is filled with loud patrons.
6. If you are also using the Opti-Source™ card, ensure that the page/music balance is
good for both "A" and "B" sources. If the balance is poor, refer to the procedure in the
Opti-Source card section of this manual for setting source levels. After the "A" and "B"
source levels are satisfactorily set, return to this section to check the page/music
balance.
®
PAGE OPTION CARD CONTROLS
15