Upper Threading - Brother 888-E31 Operation Manual

Hide thumbs Also See for 888-E31:
Table of Contents

Advertisement

f
Replace the bobbin cover.
Memo
● You can begin sewing immediately without
drawing up the bobbin thread. If you want to draw
up the bobbin thread before you start to sew,
follow to the procedure in "Drawing up the lower
thread" (page 18).

Upper threading

Set the upper thread and thread the needle.
• For details on the needle threader, see page 17.
a Spool pin
b Mark on the handwheel
CAUTION
● When threading the upper thread, carefully
follow the instructions. If the upper threading is
not correct, the thread may become tangled or
the needle may bend or break.
● Never use a thread weight of 20 or lower.
● Use the needle and the thread in the correct
combination. For details on the correct
combination of needles and threads, refer to
"Needle types and their uses" (page 19).
a
Turn on the sewing machine.
b
Raise the presser foot using the presser foot
lever.
a Presser foot lever
CAUTION
● If the presser foot is not raised, the sewing machine
cannot be threaded correctly.
c
Raise the needle by turning the handwheel
toward you (counterclockwise) so that the mark
on the wheel points up, or press
position button) (for models equipped with the
needle position button) once or twice to raise
the needle.
or
a Mark
• If the needle is not correctly raised, the sewing
machine can not be threaded. Be sure to turn
the handwheel so that the mark on the wheel
points up before threading the sewing
machine.
d
Press down on the spool pin lever to swing up
the spool pin. Then remove the spool cap.
a Spool pin
b Spool cap
CAUTION
● Do not grab the bar to raise the spool pin,
otherwise, the spool pin may bend or break.
● Be sure to raise the spool pin before use. If the
spool of thread is in the wrong place, or is set
incorrectly, the thread may tangle on the spool
pin and cause the needle to break.
e
Fully insert the spool for the upper thread onto
the spool pin.
Slide the spool cap onto the spool pin.
• The thread should be unwound from the
bottom to the front.
(needle
b Needle position button
15
1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents