Table of Contents
Advertisement
c
Hold the quilting foot in place with your right
hand, and then tighten the presser foot holder
screw using the disc-shaped screwdriver in your
left hand.
CAUTION
● Be sure to securely tighten the screws with the
disc-shaped screwdriver, otherwise the needle
may touch the presser foot, causing it to bend or
break.
d
Slide the feed dog position lever to
a Feed dog position lever
The feed dogs are lowered.
e
Turn on the sewing machine, and then select a
stitch.
f
Use both hands to hold the fabric taut, then
move the fabric to follow the pattern.
Reinforcement stitches are sewn at the beginning
and end of sewing.
a Pattern
a Presser foot holder
screw
.
g
After sewing is finished, slide the feed dog
position lever to
raise the dogs.
• Normally, the feed dog position lever is
positioned at
REINFORCEMENT
STITCHING
Reinforce points that will be subject to strain, such as
sleeve holes, inseams and pocket corners.
Stitch Name
Triple stretch
J
02
stitch
Bar tack stitch
A
42
CAUTION
● Be sure to turn off the main power before
replacing the presser foot. Otherwise, injuries
may occur if the foot controller or
stop button) is accidentally pressed and the
machine starts sewing.
Triple stretch stitching
Use triple stretch stitching to reinforce sleeve holes and
inseams.
a
Attach zigzag foot "J".
b
Select stitch
.
c
Start sewing.
• For details, refer to "Starting to sew" (page 25).
Bar tack stitching
Bar tacks are used to reinforce points subject to strain, such
as pocket corners and openings.
As an example, the procedure for sewing bar tacks at pocket
corners is described below.
and turn the handwheel to
.
Pattern No.
02
02
02
02
02
42
36
34
30
24
(start/
3
02
19
41
Hide quick links:
Advertisement
Table of Contents
