Appliances Built-In Under A Hob; Fitting The Spacers - Brandt VH900JE1 Installation Manual

EN
2 / INSTALLING YOUR DISHWASHER
•

APPLIANCES BUILT-IN UNDER A HOB

Danger:
If your worktop has a hob fitted above your dishwasher, you must fit thermal insulation
on top of your dishwasher. You can obtain an insulation kit from your dealer. Remember to
leave a space between the gas pipe and the top of your dishwasher.
•

FITTING THE SPACERS

- Measure the dimension X between the base
of the control panel and the top of the door
on the adjacent unit (Fig. 5.1).
See the table below (Fig. 5.2) to establish the
numbers for the spacers to be clipped onto
the control panel.
- Clip the assembled spacers
appliance's control panel (Fig. 5.3).
Important:
The height of the door panel plus
dimension X must not exceed 620mm to
enable the door to open.
NB:
If the overall height of the assembled
spacers is unsuitable, you can unclip them
and re-adjust them.
Fig. 5.1
Fig. 5.2
P4
onto the
Fig. 5.3
20