Position Adjustment And Mounting Dimensions Of The Display - Alpine HALO9 INE-F904D Installation Manual

Position Adjustment and Mounting Dimensions of the Display

The mounting position of this unit's Display can be adjusted (front-back/up-down/angle). When mounting the Display, confirm the mounting
position and mounting dimensions so that it does not obstruct your field of vision or impair driving.
WARNING
• In the following cases, the display cannot be mounted.
- It impairs operation of the steering wheel or various levers (gearshift, windshield wiper switch, turn signal switch, etc.)
- It impairs operation of the airbag
- It significantly impairs operation of the hazard switch
- It impairs identification or operation of any other control switches
- It impairs confirmation of gauges or warning indicators
- It interferes with vehicle equipment (switches, panels, etc.)
* Depending on the vehicle, the glove compartment or cup holders may become inaccessible, or air conditioner ventilation ducts may be covered.
Display mounting dimensions and adjustable positions
Display unit size
235.2 mm (MAX)
Adjustable Display angle and up-down position
0°
45°
20°
0
* Depending on the up-down position of the forward and back positions, there are certain positions in which the angle cannot be adjusted.
Consult "Mounting Dimensions for Angle Adjustment of the Display" (page 19) for details.
18
-EN
-20°
Front-back position
<Forward position>
70 mm
28 mm
<Back position>
50 mm
8 mm