King Canada Power Force KCG-26LS Instruction Manual page 7

ASSEMBLY
Installing beam to towbar
1) Remove beam (A) Fig.5 from shipping pallet. Get someone to help you or use
lifting equipment.
2) Tip beam up onto endplate (B) as shown in Fig.5. Make sure to obtain a helper to
hold the top of the beam during the remainder of this step. The beam is very
heavy and dangerous if it tips over.
3) Connect beam to the towbar (C) using the beam fixing shaft and cotter pin (D).
Insert cotter pin through hole in beam fixing shaft and bend it so it can't come off.
4) Pivot and lower beam (A) Fig.5 to its horizontal position. Fix beam into position
using the horizontal beam spring lock bolt (A) Fig.6.
Installing gas engine/pump assembly to the axle/tank
1) Position the gas engine/pump assembly (A) Fig.7 onto the axle/tank plate (B) and
secure it into place using 4 hex. bolts and hex. nuts (C). (The beam is not shown
for clarity purposes).
Installing suction hose from axle/tank to pump
1) Slightly loosen the hose clamps (A) Fig.8 at both ends of the suction hose (B)
(transparent hose).
2) Remove the shipping plug from the pump then slide suction hose onto the
bottom fitting (C) of the pump, secure hose by tightening the hose clamp.
3) Slide suction hose onto the axle/tank fitting (D), secure hose by tightening the
hose clamp.
LOG SPLITTER ASSEMBLY
Figure 5
Figure 6
Figure 7
Figure 8