Related Manuals for King Canada KC-6LS
Summary of Contents for King Canada KC-6LS
- Page 1 KING CANADA 6 TON - 21” LOG SPLITTER MODEL: KC-6LS INSTRUCTION MANUAL COPYRIGHT © 2011 ALL RIGHTS RESERVED BY KING CANADA TOOLS INC.
-
Page 2: Important Warranty Information
LIMITED TOOL WARRANTY King Canada makes every effort to ensure that this product meets high quality and durability standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the date the product was purchased at retail and that each product is free from defects in materials. -
Page 3: General Safety Instructions
GENERAL SAFETY INSTRUCTIONS 1. KNOW YOUR TOOL 12. ALWAYS WEAR SAFETY GLASSES. Read and understand the owners manual and labels affixed to Always wear safety glasses (ANSI Z87.1). Everyday eye- the tool. Learn its application and limitations as well as its glasses only have impact resistant lenses, thet are NOT specific potential hazards. - Page 4 SPECIFIC SAFETY INSTRUCTIONS FOR THIS LOG SPLITTER 1) It is obligatory to read the instruction manual in full before using the 18) Split wood in the direction of the grain. Do not place wood across log splitter. the log splitter and leave it in that position for splitting as it is dangerous and may damage the machine or cause injury to the 2) It is obligatory to wear safety footwear at all times to provide operator.
- Page 5 SERIOUS INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THE LOG SPLITTER DISCONNECTED FROM THE POWER SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY! KC-6LS POWER SUPPLY (120V-1 PHASE) EXTENSION CORDS WARNING: THIS LOG SPLITTER MUST BE CONNECTED TO A The use of any extension cord will cause some loss of power.
- Page 6 GETTING TO KNOW YOUR LOG SPLITTER & OPERATING GUIDELINES Getting to Know your Log Splitter Before attempting to use the log splitter, it is recommended to familiarize yourself with all the controls, operating features and safety requirements of your log splitter. 1.
-
Page 7: Assembly And Operation
ASSEMBLY & OPERATION Warning! For your own safety, do not connect the log splitter to the power source until the machine is completely assembled and you have read and understood the entire instruction manual. Warning! Never use the log splitter if it is not in perfect order or if it needs servicing. -
Page 8: Operation
OPERATION Splitting a Log This log splitter is equipped with a control system that requires both hands of the user to be operated. The left hand controls the hydraulic control lever while the right hand controls the momentary push button switch. First push the momentary push button switch (A) Fig.7 to start the motor, then lower the hydraulic control lever (B) to engage the hydraulic pusher, see Fig.7. -
Page 9: Maintenance
MAINTENANCE Checking Hydraulic Oil Level 1) Make sure the power cord is unplug from the power source. 2) Make sure the bleed screw (A) Fig.9 is tightened (closed). 3) Position the log splitter as shown in Fig.9. 4) Loosen and remove the drain bolt/dipstick assembly (B). 5) Wipe the oil off the dipstick, reinsert the drain bolt/dipstick assembly and then pull it out again. -
Page 10: Troubleshooting Guide
Oil drain bolt with dipstick is not tight Tighten the oil drain bolt with dipstick Hydraulic control valve assembly Contact closest service center. and/or seal(s) worn PARTS DIAGRAM & PARTS LISTS Refer to the Parts section of the King Canada web site for the most updated parts diagram and parts list.
Need help?
Do you have a question about the KC-6LS and is the answer not in the manual?
Questions and answers