Connection; Network Connection And Ip Assignment - Advanced Technology Video D1 Instruction Manual

2.2 Connection

• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network dome camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
• Connecting Alarms
AI(Alarm In) :
You can use external devices to signal the dome camera to react on events. Mechanical or
electrical switches can be wired to the AI (Alarm In) and G (Ground) connectors.
G(Ground) :
Connect the ground side of the alarm input and/or alarm output to the G (Ground) connector.
AO(Alarm Out) :
The dome camera can activate external devices such as buzzers or lights. Connect the device to
the AO (Alarm Out) and G (Ground) connectors.
• Connecting Video Output
• Connecting the Power
Connect the power of DC12V 380mA for the dome camera. Connect the positive(+) pole to the
'+' position and the negative(-) pole to the '-' position.

2.3 Network Connection and IP assignment

The Network Camera supports the operation through the network. When a camera is first connected
to the network it has no IP address. So, it is necessary to allocate an IP address to the device with the
"Smart Manager" utility on the CD.
1. Connect the Network Camera / device to the network and power up.
2. Start SmartManager utility (Start>All programs> SmartManager>SmartManager), the main
window will be displayed, after a short while any network devices connected to the network will
be displayed in the list.
Video Output is used for an easy zoom and focus control
when installing lens.
Connect your Video cable unit to J5 on the board.
14