Related Manuals for Advanced Technology Video CS7D37PB
Summary of Contents for Advanced Technology Video CS7D37PB
- Page 1 Mini Strip Camera Please read this manual thoroughly before use, and keep it handy for future reference. Design and specifications are subject to change without notice.
-
Page 2: Fcc Compliance Statement
FCC COMPLIANCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC INFORMATION : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. . Do not block any ventilat ion openings. Install in accord ance with the manufacturer`s instructions. 6. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. - Page 4 INTRODUCTION Features: High resolution and high performance 1/3" Color CCD Excellent picture quality 700 lines of resolution(Color) 0.1 lux(Color), 0.04ux(B/W) @ F1.2 50IRE Sensitivity Auto electronic shutter [1/60(1/50) ~ 1/100,000] Auto white balance AGC (Auto Gain Control) Use Certified / Listed Class 2 power source only 2D DNR (Digital Noise Reduction) Side Light Compensation 3.7mm Pin hole Lens...
- Page 5 Step 1 The gimbal mount surface mounted to ceiling. Default position out of the box is for vertical orientation of the camera view. For horizontal orientation of camera the housing must be opened by removing the 4,M3 button head screws located on each side of the housing. Camera module rotates 90 degrees in the desired direction.
- Page 6 Step 2 Mount the gimbal horizontally Mount the gimbal vertically Feed wire through the 3/4" hole on the gimble mount. For vertical mounting penetrate door frame at 63 inches from the finished floor. The gimbal can be mounted on the top door jam if required.
- Page 7 Step 3 Mount the gimbal horizontally Mount the gimbal vertically Center the gimbal mount to mounting surface and mark the mounting holes for the gimbal mount on the surface. Secure the gimbal mount to the surface using installer supplied self tappers for aluminum frame structure.
- Page 8 Step 4 Completing the housing installation Pull cable from headend thru the mount gimbal mount. Connect BNC connectors and mark power connection to the camera. Note: Polarities must be observed the camera is 12V DC and damage will result if power polarities are not observed.
- Page 9 DIMENSIONS inch MINI STRIP CAMERA...
-
Page 10: Specifications
SPECIFICATIONS NTSC MODEL Power source DC12~15V +/-10% Power Power consumption 130mA (1.5 Watts) Image sensor 1/3" Color CCD Number of pixels 976(H) x 494(V) 976(H) x 582(V) Scanning system 2:1 interlace 15.734KHz(H) x 59.94Hz(V) Scanning frequency 15.625KHz(H) x 50Hz(V) Sync. system Internal Electronic shutter 1/60 ~ 1/100,000 sec. - Page 12 Mini Strip Covert Camera PRINTED IN KOREA 50303703A...