Installation; Connection - Advanced Technology Video IPB3TWI Instruction Manual

C. Connect connection cable and network lines.
D. Fit the screw holes of the mount base into the plastic anchors.
E. Remove the conduit knockout punched for the cable entry.
F. Screw up the mount screws (M5x20).
G. Adjust the camera suitably using the pan & tilt function, and fasten and fasten the mount
screws (M6x16) to fix the camera.

2. Installation

2.1 Connection

• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
You can also use a router featuring PoE (Power over Ethernet) to supply power to the camera.
Micro SD memory slot on the Rear Board

Remove the rear cap of the camera to insert the SD memory card.
• Connecting the Power
Connect the power of DC12V for the network camera. Connect the positive(+) pole to the '+'
position and the negative(-) pole to the '-' position for the DC power.
Be careful not to reverse the polarity when you connect the power cable.

You can also use a router featuring PoE (Power over Ethernet) to supply power to the

camera.
The heater will operate properly only by the power source of DC 12V.

If using PoE, the heater will not operate at all.

If PoE and DC 12V are both applied, this camera will get supplied with power from PoE.

11