Electrical Safety Warnings - Saber Compact ATD-80050 Owner's Manual

Electrical Safety Warnings:

WARNING:
Read all safety warnings and instruc ons. Failure to follow all warnings and
instruc ons may result in electric shock, re and/or serious injury or death.
WARNING:
Before conne ng a tool to a power supply, always check to ensure the power supply
corresponds to the voltage on the nameplate of the tool. A power supply with a voltage greater than
that spec ed for the tool can result in serious injury to the user, as well as damage to the tool. Using a
power supply with a voltage less than the nameplate ra ng is harmful to the motor. If in doubt, do not
plug in the tool.
WARNING:
Grounded tools must be plugged into an outlet properly installed and grounded in
accordance with all codes and ordinances. This tool is equipped with a 3-prong plug and a 3-wire
grounding system. Never remove the grounding prong or modify the plug in any way. Do not use any
adapter plugs. Check with a qua ed electrician if you are in doubt as to whether the outlet is properly
grounded.
NOTE
: Double insulated tools are equipped with a polarized plug (one blade is wider than the
other). This plug will t in a polarized outlet only one way. If the plug does not t fully in the outlet,
reverse the plug. If it s ll doesn't t, contact a qua ed electrician to install a polarized outlet. Do not
change the plug in any way.
WARNING:
To reduce the risk of electric shock, DO NOT use in damp condi ons, on wet surfaces,
or expose to rain. Do not plug in this tool or operate it with wet hands or while standing in water.
WARNING:
Never use the cord for carrying, pulling or unplugging the power tool. Grasp plug
and pull to disconnect from outlet. Keep cord away from heat, oil, sharp edges or moving parts. Replace
damaged cords immediately.
WARNING:
Do not carry the power tool with your nger on the switch. Ensure the switch is in
the o posi on before plugging the tool into the power outlet. In the event of a power failure while a
tool is being used, turn the switch o to prevent surprise star ng when the power is restored.
WARNING:
Always remove the power cord from the electric outlet when making adjustments,
changing parts, cleaning or working on the tool.
WARNING:
Care should be taken to arrange the cord so it will not be stepped on, tripped over,
or otherwise subjected to damage or stress.
WARNING:
Never a empt to plug in or operate equipment with defec ve or damaged wires,
power cord or power cord plug. Have any defec ve or damaged parts replaced immediately by qu
personnel.
ed