Advertisement
Available languages
Available languages
tightening
torque
wrench�
• Install socket wrench 8 onto the fastener head�
Note: install socket wrench 8 onto the fastener
head only when the air tool is turned off.
• Turn on the air tool and perform twisting or untwisting�
You can choose the operating duration when screwing
by practical testing�
• Turn off the air tool and remove socket wrench 8
from the fastener head�
Air tool maintenance / preventative
measures
Before execution of any procedures, disconnect
air tool from compressor.
Air tool lubrication (see fig. 5)
Water and pollution particles in the compressed air
cause corrosion and lead to the wear of blades, valves,
etc� To prevent the mentioned, the air tool should be
lubricated before / after every using�
• Put a few drops of oil (use oil 46#) from oiler 5 into
quick-removable connector 6 (see fig. 5).
• Connect the air tool to the compressor and turn it on
for 5-10 seconds�
• The oil may bleed out of holes 10 - wipe it with a cloth�
The manufacturer reserves the possibility to introduce changes.
using
the
torque-measuring
After-sales service and application service
Our after-sales service responds to your questions
concerning
maintenance
product as well as spare parts� Information about
service centers, parts diagrams and information
about spare parts can also be found under:
www.crown-tools.com.
Transportation of the air tools
• Categorically not to drop any mechanical impact on
the packaging during transport�
• When unloading / loading is not allowed to use
any kind of technology that works on the principle of
clamping packaging�
Environmental protection
Recycle
disposing as waste.
Air tool, accessories and packaging should be
sorted for environment-friendly recycling�
The plastic components are labelled for categorized
recycling�
These instructions are printed on recycled paper
manufactured without chlorine�
English
9
and
repair
raw
materials
instead
of
your
of
Advertisement
