Table of Contents
Advertisement
TROUBLESHOOTING
Remote Control Pairing
If the remote control becomes unresponsive or if you have replaced the batteries, you will
need to re-pair the remote control by pressing and holding the mode button for 5 seconds.
Connection Indicator
•
FLICKERING: The treadmill is NOT connected to the App.
•
OFF: The treadmill is connected to the App.
Error Indicator
•
E01: Software overcurrent
•
E02: Hardware overcurrent
•
E03: IPM Module Overheating
•
E04: Low-voltage Protection
•
E05: Overvoltage Protection
•
E06: Motor phase loss protection
•
E07: Motor phase loss protection
•
E08: Sensor fault
•
E09: Motor unable to start
•
E12: Motor overcurrent
•
E13: Overloading protection
•
E14: Hall signal loss
•
E15: Communication fault
Advertisement
Table of Contents
