Programming Mode - LG RN1329CD1P Owner's Manual

14

PROGRAMMING MODE

PROGRAMMING MODE
1. Programming mode
You can check machine information or change setting on Program setup or Diagnostic test.
There are two methods that you can enter programming mode.
■ How to enter "Programming mode"
You can enter programming mode only for Idle state
and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of the coin
box.
4) Display will show "
- OPL Type
1) Push the High Temp. and Low Temp. button at the
same time.
2) Push the Med Temp. button 3 times.
3) Push the Srart button.
4) Display will show "
Coin Box Key
Coin Vault
COIN TYPE
NOTE
• If you turn on the power without connecting the meter case for the first time, the machine will display
• When the machine comes from the factory, it is set in the coin type. You can change Card/Coin type by button.
(For more information refer to SETUP mode's
• The machine will display "PUSH" for OPL type
".
"
Insert debit card
CARD TYPE
■ How to use button
You can change Dryer vend price, cycle time and Cycle
parameters, etc.
Press button
High Temp.
Med Temp.
Low Temp.
No Heat
Start
.)
Description
Move to upper level
Move to the mode in the
same level (+)
Move to the modes in the
same level (-)
-
Enter the selected mode
OPL TYPE
.