Part 5. Programming Mode - LG RN1329AD5 Owner's Manual

Part 5 PROGRAMMING MODE
1 1
Programming mode
You can check machine information or change setting on Program setup or Diagnostic test.
There are two methods that you can enter programming mode.
How to enter "Programming mode"
You can enter programming mode
only for Idle state and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of the
coin box.
4) Display will show "
- OPL Type
1) Push the WHITES & DELICATES and
DELICATES button at the same time.
2) Push the PERM.PRESS button 3 times.
3) Push the START button.
4) Display will show "
Coin Box Key
Coin Vault
COIN TYPE
Note
• If you turn on the power without connecting the meter case for the first time, the machine will display
• When the machine comes from the factory, it is set in the coin type. You can change Card/Coin type by button.
(For more information refer to SETUP mode's
• The machine will display "PUSH" for OPL type
• Do not enter the "Vend type set up" mode if the machine is a coin type. You cannot restore it back to Coin type
without a special card reader and a service card after it has been changed to Card type in the set up mode.
".
"
Insert debit card
CARD TYPE
.)
How to use button
You can change Dryer vend price, cycle time and
Cycle parameters, etc.
Press button
WHITES &
COLORS
PERM. Move to the mode in the
PRESS
DELICATES Move to the modes in the
NO HEAT
START
Enter the selected mode
Description
Move to upper level
same level (+)
same level (-)
-
OPL TYPE
.
1 3