Mounting And Wiring; Unpacking, Installation And Transport - Beckhoff CX2500-0070 Manual

Mounting and wiring

3 Mounting and wiring
3.1

Unpacking, installation and transport

The specified storage conditions must be adhered to (see "Technical data").
Dimensions and weight of the individual modules
Dimensions (W x H x D): 24 mm x 100 mm x 55 mm
Weight: approx. 195 g (system interface)
Unpacking
Proceed as follows to unpack the unit:
1. Remove packaging.
2. Do not discard the original packaging. Keep it for transporting the device in the future.
3. Check the delivery for completeness by comparing it with your order.
4. Please keep the associated paperwork. It contains important information for handling the unit.
5. Check the contents for visible shipping damage.
6. If you notice any shipping damage or inconsistencies between the contents and your order, you
should notify Beckhoff Service.
Danger of damage to the device!
During transport in cold conditions, or if the device is subjected to extreme temperature differences, con-
densation on and inside the device must be avoided. Prior to operation, the device must be allowed to
slowly adjust to room temperature. Should condensation occur, a delay time of approximately 12 hours
must be allowed before the unit is switched on.
Installation
The devices are designed for installation in control cabinets.
Shipping and relocation
Despite the robust design of the unit, the components are sensitive to strong vibrations and impacts. During
transport, your computer should therefore be protected from excessive mechanical stress. Therefore, please
use the original packaging.
10
NOTE
Version: 1.1 CX2500-0070