Before The First Use - Maxwell VT-8431 W Manual Instruction

•
For environment protection do not discard the unit with usual
household waste after its service life expiration; apply to a
specialized center for further recycling.
•
Keep the unit in a dry cool place out of reach of children and
disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE ONLY

BEFORE THE FIRST USE

After unit transportation or storage at low temperature
keep it for at least three hours at room temperature before
switching on.
•
Unpack the unit and remove any stickers that can prevent
unit operation.
•
Unwind the power cord to its full length.
•
Check the unit for damages; do not use it in case of damages.
•
Before plugging the unit in make sure that the operating volt-
age of the unit corresponds to the voltage of your mains.
HAIR STRAIGHTENING
•
The unit can be used for both long and short hair.
•
Use the unit only on healthy undyed and not permed hair or
use it along with special hair straightening products.
•
If your hair has been dyed or permed, use the unit rarely.
•
For the best results the hair should be clean and dry.
•
Place the unit on a flat steady heat-resistant surface.
•
Insert the plug into the socket, set the power switch (3) to
the "ON" position (the unit is switched on), the power indi-
cator (2) will light up.
Note: During the first operation some smell from the heating
element is possible, this is normal.
•
Let the unit heat up for 1-2 minutes.
•
Divide combed hair into locks of equal width (about 5 cm).
•
Press on the handle (4) and place the hair lock between the
plates (1).
•
Release the handle (4) and slide the plates effortlessly until
the hair tips.
IMPORTANT: do not keep the plates on the same area of the
hair lock for more than 2 seconds.
•
After that start straightening the next hair lock.
•
Do not use the unit for more than 30 minutes.
•
Cool your hair down before final styling.
•
Avoid contact of heated surfaces with your face, neck and
other parts of your body.
•
After you finish using the unit set the switch (3) to the «OFF»
position (the unit is switched off), the power indicator (2)
will go out and then you can unplug the unit. Let the unit
cool down.
ENGLISH
5
16.03.2017 12:17:18