Software Setup; Figure 6 - Nema Box Cover Removed - RaceAmerica 64835A Manual

STEP 6 - Connect the power
Power is supplied to the scoreboard unit
through the NEMA watertight junction box located
on the Position 5/10 enclosure behind the Position
5/10 digit panel. Remove the screws holding the
Rear Power Access Panel (lower right corner on
rear of enclosure). Remove the four corner screws
to reveal the terminal strip (Figure 6). AC power
can be installed to power the scoreboard using a
3/4in conduit attached directly to the bottom of
the watertight enclosure.
To install an AC power cord, attach a 3/4in
conduit to the NEMA watertight junction box and
Figure 6 - Cover removed from NEMA
watertight junction box.
RaceAmerica Racetrack Leader Boards
slide the powerwire through the and connect power
as follows (Figure 6):
AC power connection label:
L = live or hot side of AC power
N = neutral side of AC power
G = ground lead of AC power
Re-install the cover to the NEMA
watertight junction box to seal the electrical
connection.

SOFTWARE SETUP

STEP 1 - Download Software
Go to the RaceAmerica website at http://
www.raceamerica.com and download the model
3130A Racetrack Scoreboard Utility PC Software
from the Licensed Sofwtare download page using
the Software License issued at time of purchase.
The ZIP file contains an install file for FTDI
Drivers and an install file for the RaceAmerica
software.
STEP 2 - Install the Software
Open the ZIP file and drag the two EXE
files to the desktop. Double click the FTDI Drivers
Install.exe file to install the drivers. Follow the
onscreen instructions and wait for completion.
Double click the second EXE file to install
the RaceAmerica software. Follow the onscreen
instructions and wait for completion.
STEP 3 - USB Wireless Unit
Attach the antenna to the 4520/4620
Wireless Unit. Connect the USB cable to the PC
and to the Wireless Unit. The Windows operating
system will recognized the new device and begin
installation of the drivers. This process can take
several minutes so be patient. Once the drivers
are installed, Windows will display a message of
a successful installation. Do not unplug the USB
cable. Windows will recognize the device and
9