ABB ACH580-01 PxR R3 Instructions Manual page 6

REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/12 , R2/R3/R4
Step Instruction
16
Secure the support plate using the four (4) M4x16 screws that were
removed earlier.
Using a T25 bit, torque to 18 in-lb (2 Nm).
17
Secure the ground wire to the drive.
R3 Frame: Using a PZ3 bit, torque to 14 in-lb (1.5 Nm).
R4 Frame: Using a PZ3 bit, torque to 27 in-lb (3 Nm).
18
Connect the input wires (from fuse block) to the Input Terminals of
the drive.
Yellow U1 to L1
Black V1 to L2
Red W1 to L3
F3 Frame: Using a PZ2 bit, torque to 31 in-lb (3.5 Nm).
R4 Frame: Using a T20 bit, torque to 35 in-lb (4 Nm).
19
Place the top of the drive cover on first, then press down on the
bottom.
R3 & R4 Frame: Using a T20 bit, torque to 14 in-lb (1.5 Nm).
Diagram
6