Summary of Contents for ABB ACH580-01 PxR Frame R2
Page 1
— ACH580-01 PxR, UL Type 1/12 Frame R2/R3/R4 Base drive replacement instructions Purpose or Scope The following are the instructions for replacing an ACH580-01 UL Type 1 & 12 (Frames R2, R3 & R4) drive in PxR enclosures. Equipment required*: –...
Page 2
REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/ 12, R2/R3/R4 Step Instruction Diagram NOTE: If needed, back-up parameters prior to disconnecting power. Turn off source power and wait 5 minutes for the DC bus capacitors to discharge. Turn handle to the off position. Rotate latches clockwise and open the enclosure door.
REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/ 12, R2/R3/R4 Step Instruction Diagram Cut zip tie and remove the CDPI from drive. Set aside. NOTE: Remove any additional drive I/O wiring. Using a PZ2 bit, loosen and remove wires from the input terminals of the drive.
Page 4
REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/ 12, R2/R3/R4 Step Instruction Diagram Using a T30 bit, loosen the four (4) M6 screws securing the drive, four (4) turns of the screw. NOTE: Do not remove the screws completely. Only loosen enough to be able to lift the drive off the screws.
Page 5
REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/ 12, R2/R3/R4 Step Instruction Diagram R2 Frame: Using a T20 bit, loosen and remove two (2) M4x8 screws. Remove conduit assembly. R3 Frame: Using a T20 bit, loosen and remove two (2) M4x16 screws.
Page 6
REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/ 12, R2/R3/R4 Step Instruction Diagram Place collar around drive. Using a T20 bit, secure the drive using the M4x20 screws that were removed earlier. Using a T20 bit, torque to 14 in-lb (1.5 Nm). Secure the ground wire to the drive.
Page 7
REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/ 12, R2/R3/R4 Step Instruction Diagram Connect the input wires (from fuse block) to the input terminals of the drive. Yellow U1 to L1 Black V1 to L2 Red W1 to L3 R2 Frame: Using a PZ2 bit, torque to 14 in-lb (1.5 Nm). F3 Frame: Using a PZ2 bit, torque to 31 in-lb (3.5 Nm).
Page 8
REPLACEMENT INSTRUCTIONS | ACH580-01 PXR UL TYPE 1/ 12, R2/R3/R4 Step Instruction Diagram Power and reprogram the drive. Test and verify drive operation and motor direction. Back-up and save parameters to the keypad prior to putting the drive back into service.