Speakman SA-2504 Instructions

INSTRUCTIONS FOR MODELS

SA-2504
HAND TOWEL BAR
SA-2505
PAPER HOLDER
SA-2506
ROBE HOOK
SA-2507-18
18" TOWEL BAR
SA-2507-24
24" TOWEL BAR
SA-2508
RESERVE PAPER HOLDER
For additional assistance or service please contact:
SPEAKMAN
®
800-537-2107
customerservice@speakman.com
www.speakman.com
92-SA-2500-01

TOOLS AND SUPPLIES

Pencil Level
Phillips Hex Key Drill
Screwdriver (included)
Drill Bit Phillips
3
Ø / " Drive Bit
16
IMPORTANT
• Do not over-tighten any connections or damage
may occur.
• Be sure to read instructions thoroughly before
beginning installation.
• This installation manual covers several models.
While the appearance of your model may vary,
the installation steps required are the same as
shown in this manual.

SAFETY TIPS

• Cover your drain to prevent loss of parts. Be sure to
wear eye protection.
• If mounting to a tile surface, ensure you acquire
appropriate mounting hardware capable of supporting
the accessory in use. Follow the instructions included
with the manufacturer's mounting hardware.

MAINTENANCE

Your new Speakman Product is designed for years of
trouble-free performance. Keep it looking new by
cleaning it periodically with a soft cloth. The use of harsh
chemicals and abrasives on any of the Speakman custom
finish products may damage the finish and void the
product warranty. Please be sure to only use approved
cleaners. Please contact Speakman for any clarification
of acceptable cleaners.

WARRANTY

Warranty information can be found at:
www.speakman.com
1
If the Mounting Plate(s) (1) come pre-installed
in the Accessory (2), remove the Mounting
Plate(s) by loosening (but not removing) the
pre-installed set screw at bottom with the
included Hex Key.
2
At the selected height, mark center point of
mounting locations onto wall referencing
the rough in diagram.